i
mount books ®
AVAILABLE IN FIVE PACKS OF ONE SIZE
- Order For Your Future Needs
- Available In All Metro Colors
Small Black Edge Line Shows
When Print Mounted In Place.
 
|
|
Mounting Instructions
1) Make sure all your prints are correct size and are cut with perfect 90 degree slices. Note that cheaper paper cutters do not cut prints so they are perfect dimensions. Prints from labs often vary in size. You will need to use a Roto Trimmer Type Paper Cutter.
2)Peel back from the center 1" of the release paper and fold down.
3) Lay your print over the page and center it. Line up carefully on the exposed adhesive, careful not to press down until happy with position.
4) Next press down the print along the exposed adhesive.
5) With your fingers,
gently pull out the release paper while smoothing out the print SLOWLY
to avoid bubbles.
6) If you like use a soft old washed T shirt to "buff" the print surface a few seconds.
7) The adhesive is permanent after a few moments. Easy.