|
MOUNTING
PRINTS INSTRUCTIONS:
1) Cut all your
prints to exactly the correct size using a ROTO TRIMMER.
We seen them at Kinko's, Lab Counters, Or buy Fiskar's (Office Supply
Stores)
2) Peel back
from the center 1" of the release paper and fold down.
3) Lay your
print over the page and center it. Line up carefully on the exposed
adhesive, careful not to press down until happy with position.
4) Next press
down the print along the exposed adhesive.
5) With your
fingers, gently pull out the release paper while smoothing out the
print SLOWLY to avoid bubbles. Two person team may be easier.
6) If you like
use a soft old washed T shirt to "buff" the print surface
a few seconds being careful to not scratch the print surface.
7) The adhesive
is permanent after a few moments. Easy.
|