MOUNTING PRINTS INSTRUCTIONS:

1) Cut all your prints to exactly the correct size using a ROTO TRIMMER.
We seen them at Kinko's, Lab Counters, Or buy Fiskar's (Office Supply Stores)

2) Peel back from the center 1" of the release paper and fold down.

3) Lay your print over the page and center it. Line up carefully on the exposed adhesive, careful not to press down until happy with position.

4) Next press down the print along the exposed adhesive.

5) With your fingers, gently pull out the release paper while smoothing out the print SLOWLY to avoid bubbles. Two person team may be easier.

6) If you like use a soft old washed T shirt to "buff" the print surface a few seconds being careful to not scratch the print surface.

7) The adhesive is permanent after a few moments. Easy.

Not Returnable if imprinted or after mounting prints. Available in any quantity/combination.